ITT Hoffman Steam Traps

 

 ITT Hoffman Series 17C Steam Traps

The Hoffman Series 17C Balanced Pressure Thermostatic Steam Traps are for institutional, commercial and residential heating system applications such as schools, hospitals, apartment buildings homes or others where low or moderate water hammer may occur.  The Series 17C Subcooling for extremely efficient system operation and elimination of flash steam losses on low pressure systems. Sizes available: 1/2" NPT Angle, Vertical.  Replaceable Dura-stat® module.  3-Year Warranty.  Meets Mil specification WW-T-696-E Type V, Style A, Class 1 and 2.  The Series 17C has stainless steel components and is resistant to moderate water hammer and chemical attack.  The Series 17C maximum operating pressure is 25 psig.
 ITT Hoffman Series C & X Steam Traps
Hoffman Series C & X Steam Trap The Hoffman Specialty F&T traps Series C & X are recommended for modulating pressures where varying loads are present, and steam pressures vary from maximum to vacuum. The Series C & X traps vent air at very low pressures, handle start up air loads, operate against back pressure and provide continuous condensate drainage. The Hoffman Specialty "X" series F&T traps are high capacity steam traps: Use anywhere that heat is quickly disbursed, thereby creating a lot of condensate. These F&T traps have the inlet on the top end of the steam trap's cover, and the outlet on the bottom end of the steam trap cover. The "X" Series cast iron trap is available in working steam pressures of 15, 30, 75, 125 & 175 psi. The 2" FTO30X, same end inlet to outlet center-to-center dimension of 6-5/8", a height of 15", a width of 10", a depth of 15-1/2", and a weight of 70lbs.
 ITT Hoffman Series H Steam Traps
ITT Hoffman Series H Steam Traps The Hoffman Specialty F & T traps Series H are recommend for modulating steam pressure where widely varying loads are present, and pressures vary from maximum to vacuum. The Series H steam traps vent air at very low pressures, handle start up air loads, operate against back pressure and provide continuous condensate drainage. The Hoffman Series H float & thermostatic trap has inlets and outlets on both sides of the steam trap, this allows for more flexibility when piping-in the steam trap. Simply insert a pipe plug into the inlet / outlet that you will not be using. The Hoffman F&T traps are available in steam operating pressures at 15, 30, 75, 125 and 175 psi. The 1-1/2" FTO15H has a inlet to outlet width of 6-3/8" for in and out opposite side, or, same side inlet to outlet center-to-center dimension of 5-1/4", a height of 7-11/16" and a weight of 20lbs.

 


Contact Us Directly:

Toll Free:    1-800-780-3776
Int'l Phone: 770-957-9599
Int'l Fax:     770-957-9563
E-Mail: Sales@powerppi.com

| Home | Services | Search PPI | Contact Us |

© 2011 to 2012. Power Plus International. All rights reserved.

Mailing Address:
Power Plus International
143 McDonough Parkway
McDonough, GA 30253
Boilersupplies.com

Home | Services | Contact Us