|
The
Series
900 Gauge Cocks
have Drop Forged Steel Bodies, Stainless
Steel Trim and Safety Ball Checks to
shut off the flow automatically if the
glass should break. The ball can be
omitted upon request. They have
renewable seats and union bonnet. The
900 series gauge cocks can be changed
from plain to quick closing by replacing
the bonnet sleeve and stem. When
specified the stem can be furnished for
Backseating which permits repacking
while under pressure. This is
accomplished by backing out the stem to
its limit so that the knob on the end of
the stem seats against the sleeve which
stops the fluid from reaching the
packing. The various types of
connections that are available make the
series 900 cocks adaptable for most
piping requirements.
The special
Offset feature was designed to
facilitate easy cleaning of the inside
of the gauge. The drain and vent
connections are in a direct line with
the gauge liquid chamber and are offset
7/8” from the center line of the vessel
connection. It is possible to clean the
inside of an end connected gauge through
the drain and vent connections without
removing the gauge from service.
The union
gauge connections when used on end
connected gauges makes it possible to
turn the gauge to any desired angle for
the most convenient visibility; when
connected to the side of the gauge, it
is possible to mount the gauge in an
inclined position at any desirable
angle.
The union
vessel connections makes installation
easier and provides access to the ball
check.
Gauge cocks
furnished with Handwheel operation. |
