We found a better way to ELIMINATE shutdowns!



		The End Cap/Clean Out Cover Serves as a Line Tap By the Use of an Adaptor
Jomar highly recommends reading the installation instructions available with each valve and available by clicking the link to the left of this page. The installer is responsible for any liability resulting from improper installation of any Add-A-Valve device. Jomar will not be held responsible, nor will it exchange or provide a refund for any improperly installed Add-A-Valve device.

The Add-A-Valve is an Emergency Shut Off Tool used to install a new valve or remove a defective valve.

A defective valve may be replaced or a new ball valve may be installed on Hot or Cold Water, including hot or chilled H₂O Glycol systems, under pressure, from 0 to 250 PSI/17 bar Max. on L, K, or Metric copper tubing, without shutting off the water, in 30 minutes or less!

Important Notice: On Sizes 1-1/4" - 2" on Multi-Story Buildings, the pumps must be shut off prior to the Add-A-Valve package installation.

Size Range: 1/2" - 2"


ADD-A-VALVE
Part No.	Size	Price
800-103ADD	1/2"	$235.40
800-104ADD	3/4"	$298.84
800-105ADD	1"	$424.92
800-106ADD	1-1/4"	$672.58
800-107ADD	1-1/2"	$837.67
800-108ADD	2"	$1,294.70

Note: Add-A-Valve package includes S-100 DUE of comparable size (1/2"-2"), along with one 1/4 pint of JomarSeal Tighter-Than-Tite Pipe Joint/Gasket Thread sealant with alternate Teflon seal and two air test end caps with Schrader valves mounted.

Contact Us Directly:

Toll Free: 1-800-780-3776
Int'l Phone: 770-957-9599
Int'l Fax: 770-957-9563
E-Mail: Email Your Request

Mailing Address: Power Plus International
143 McDonough Parkway
McDonough, GA 30253